Dedicated to the research and development of hydraulic system components, providing services to over 100000 enterprises.
-
Service
-
Share:
Wheels (OMK)
If you have any questions, please contact us at the first time!
Product category:
Product Keywords:
- Product description
-
Product Advantages
Imported Oil Seal
Uses Hansheng sealing rings for pressure resistance, with a three-layer seal to prevent oil leakage.
Distribution Plate
Uses powder metallurgy valve plate, wear-resistant, high precision.
Stator-Rotor Set
Precision machined by imported machining centers, flatness error not exceeding 2mm.
Output Shaft
Uses low-carbon alloy steel output shaft, carbon-nitrogen co-infiltration, cyanidation treatment, longer lifespan.
Bearing
Uses Siemon-Si S-type three bearings for strong radial force and high pressure resistance.
Delivery Time
Fast delivery, lead time 2-7 days, accepts custom processing.
OMK Series Performance Parameters
Displacement (ml/r) 160 195 245 315 395 490 Flow Rate (LPM) Max Continuous 95 95 95 95 95 95 Intermittent 115 115 130 130 150 150 Speed (RPM) Max Continuous 560 440 354 290 225 180 Intermittent 670 535 480 395 350 285 Pressure (Mpa) Max Continuous 20.5 20.5 20.5 20.5 19 14 Intermittent 31 31 26 26 24 17 Torque (N*m) Max Continuous 450 565 700 856 1020 950 Intermittent 680 855 890 1085 1285 1154 Conventional Motor Selection
Four-hole Parallel Key
Four-hole Spline
Motor Usage Guide
To ensure OMM, OMP, OMR, BM3, BM4, and other cycloid hydraulic motors operate in optimal conditions, the following is recommended:
1. Oil Temperature: Normal operating oil temperature is 20°C~ 60°C, maximum system operating temperature is 90°C (should not exceed one hour).
2. Filter and Oil Cleanliness Level: Filter accuracy is 10-30 microns. It is best to install a magnet at the bottom of the oil tank to prevent metal particles from entering the system. The solid contamination level of the working oil should not exceed 19/16.
3. Oil Viscosity: Kinematic viscosity at 40°C oil temperature is 42-74 MM2/S. Hydraulic oil can be selected based on actual operating and ambient temperatures.
4. Motors can be used in series or parallel. When used in series or parallel, if back pressure exceeds 10MPa (speed below 200RPM), pressure must be relieved through an external drain port. It is best to connect the external drain port directly to the oil tank.
5. The output shafts of BMS, BMSY, BMT, BMV, and BMK6 series motors can withstand significant axial and radial loads.
6. The optimal operating condition for the motor should be chosen at 1/3 to 2/3 of the rated operating condition.
7. To ensure a long service life for the motor, when applying load, it should first be run at 30% of the rated pressure for approximately 1 hour; in all cases, ensure the motor is filled with oil before applying load.
Wheels (OMK)
If you have any questions, please contact us at the first time!
Product category:
Optimization keywords:
Related Products
Product Inquiry
We will contact you within one working day. Please pay attention to your email.
Address
No. 215 Jianhua South Street, Yuhua District, Shijiazhuang City, Hebei Province, China