Dedicated to the research and development of hydraulic system components, providing services to over 100000 enterprises.
-
Service
-
Share:
2-hole (BME2)
If you have any questions, please contact us at the first time!
Product category:
Product Keywords:
- Product description
-
Product Advantages
Imported Oil Seal
Uses Hansheng sealing rings to bear pressure, with three layers of seals to prevent oil leakage.
Distribution Plate
Uses powder metallurgy valve plates for wear resistance and high precision.
Stator-Rotor Set
Precision machined by imported machining centers, with flatness error not exceeding 2μm.
Output Shaft
Uses low-carbon alloy steel output shaft, carbonitrided and cyanided for longer life.
Bearings
Uses Simonsi S-type three bearings, with strong radial force and high pressure resistance.
Lead Time
Rapid delivery, lead time 2-7 days, custom processing accepted.
BME Series Performance Parameters
Displacement 63 80 100 125 160 200 250 305 400 Flow Rate LPM Continuous Operation 60 60 60 60 60 60 60 60 60 Intermittent Operation 75 75 75 75 75 75 75 75 75 Speed RPM Continuous Operation 850 675 540 432 335 270 216 177 135 Intermittent Operation 980 800 645 516 405 325 258 210 160 Pressure Mpa Continuous Operation 15 18 18 18 18 18 18 15 15 Intermittent Operation 18 21 21 21 21 21 21 18 18 Torque Nm Continuous Operation 128 195 244 305 390 487 609 619 812 Intermittent Operation 144 214 268 334 428 535 669 699 917 Max Permissible Back Pressure 10MPa Motor Usage Guide
To ensure optimal operation of cycloid hydraulic motors such as OMM, OMP, OMR, BM3, BM4, etc., the following is recommended:
1. Oil Temperature: Normal operating oil temperature 20°C~ 60°C, maximum system operating temperature 90°C (should not exceed one hour).
2. Filter and Oil Cleanliness Level: Filter precision is 10-30 microns; it is best to install a magnetic block at the bottom of the oil tank to prevent metal debris from entering the system. The solid contamination level of the working oil should not be higher than 19/16.
3. Oil Viscosity: The kinematic viscosity at an oil temperature of 40°C is 42-74 mm²/s. Hydraulic oil can be selected based on actual operating and ambient temperatures.
4. Motors can be used in series or in parallel. When used in series or parallel, if the back pressure exceeds 10 MPa (speed below 200 RPM), pressure must be relieved through the external drain port. It is best to connect the external drain port directly to the oil tank.
5. The output shafts of BMS, BMSY, BMT, BMV, and BMK6 series motors can withstand significant axial and radial loads.
6. The optimal operating condition for the motor should be chosen within 1/3 to 2/3 of the rated condition.
7. To ensure a long service life for the motor, when applying load, it should first run at 30% of the rated pressure for about 1 hour. In any case, ensure the motor is filled with oil before applying load.
2-hole (BME2)
If you have any questions, please contact us at the first time!
Product category:
Optimization keywords:
Related Products
Product Inquiry
We will contact you within one working day. Please pay attention to your email.
Address
No. 215 Jianhua South Street, Yuhua District, Shijiazhuang City, Hebei Province, China