Dedicated to the research and development of hydraulic system components, providing services to over 100000 enterprises.
-
Service
-
Share:
Wheel Motor (BME)
If you have any questions, please contact us at the first time!
Product category:
Product Keywords:
- Product description
-
Product Advantages
Imported Oil Seals
Uses Hansheng sealing rings for pressure bearing, with a three-layer seal to prevent oil leakage.
Distribution Plate
Uses powder metallurgy valve plates for wear resistance and high precision.
Stator-Rotor Set
Precision machined by imported processing centers, flatness error not exceeding 2μm.
Output Shaft
Uses low-carbon alloy steel output shaft, carbonitriding and cyanidation treated for longer life.
Bearings
Uses Siemons S-type triple bearings, strong radial force and high pressure resistance.
Delivery Time
Rapid delivery, lead time 2-7 days, accepts custom processing.
BME Series Performance Parameters
Displacement 63 80 100 125 160 200 250 305 400 Flow LPM Continuous Operation 60 60 60 60 60 60 60 60 60 Intermittent Operation 75 75 75 75 75 75 75 75 75 Speed RPM Continuous Operation 850 675 540 432 335 270 216 177 135 Intermittent Operation 980 800 645 516 405 325 258 210 160 Pressure Mpa Continuous Operation 15 18 18 18 18 18 18 15 15 Intermittent Operation 18 21 21 21 21 21 21 18 18 Torque Nm Continuous Operation 128 195 244 305 390 487 609 619 812 Intermittent Operation 144 214 268 334 428 535 669 699 917 Max. Permissible Back Pressure 10MPa Motor Usage Guide
To ensure optimal operation of cycloid hydraulic motors such as OMM, OMP, OMR, BM3, BM4, the following recommendations are made:
1. Oil Temperature: Normal operating oil temperature is 20°C ~ 60°C, with a maximum system operating temperature of 90°C (not to exceed one hour).
2. Filter and Oil Cleanliness Level: Filter filtration accuracy is 10-30 microns. It is best to install a magnetic block at the bottom of the oil tank to prevent metal shavings from entering the system. The solid contamination level of the working fluid should not be higher than 19/16.
3. Oil Viscosity: The kinematic viscosity at an oil temperature of 40°C is 42-74 MM2/S. Hydraulic oil can be selected based on actual working and ambient temperatures.
4. Motors can be used in series or parallel. When used in series or parallel, if the back pressure exceeds 10MPa (speed below 200RPM), it is necessary to relieve pressure using an external drain port. It is best to directly connect the external drain port to the oil tank.
5. The output shafts of BMS, BMSY, BMT, BMV, and BMK6 series motors can withstand significant axial and radial loads.
6. The optimal operating condition for the motor should be chosen at 1/3 to 2/3 of the rated operating condition.
7. To ensure a long service life for the motor, it should first be run at 30% of the rated pressure for approximately 1 hour when applying load. In any case, ensure the motor is filled with oil before applying load.
Wheel Motor (BME)
If you have any questions, please contact us at the first time!
Product category:
Optimization keywords:
Related Products
Product Inquiry
We will contact you within one working day. Please pay attention to your email.
Address
No. 215 Jianhua South Street, Yuhua District, Shijiazhuang City, Hebei Province, China